|
Aquarium Stand Plans Newsletter
"Aquarium Projects for the Modern Aquarist"
October,
2005
In this issue you will find...
1) New Aquarium Stand Plans - Now Available !!
2) Before
you add water.
For those of you who prefer the HTML version of our
newsletter, you can still read it in this format at:
http://www.aquarium-stand-plans.com/newsletters.htm
Updates
:
Many
exiting things underway this month.
Looking
for the right tools, supplies and hardware for your project? Check
out Rockler
Woodworking
These
guys are GREAT !! Order all you need online and usually have it on
your doorstep the same week..
We've had many requests so .....in the works will be a
bow front design
aquarium stand plan.
Updates to this will be added once the final touches on these plans have
been completed ....
Stay Tuned !!
Drop us a note so that we can all benefit from your letters ...
Do
you have a plan you are looking for?
rick@aquarium-stand-plans.com
Be sure to watch for more great DIY projects and plans that will become
available from time to time as well.
========================================================
1) Aquarium Stand Plans - Now Available !! - Go to
Their
currently available with 3 super bonuses ..........
Measured for a 60"x18"x24" (100 gallon) tank. These plans are very adaptable
for a variety of different set-ups simply alter the measurements to fit your
exact needs.
http://www.aquarium-stand-plans.com
- look for the BUY NOW button !!!!
=======================================================
2) Before you add water -
Check for leaks in your aquarium?
Many of us will - at some point experience small leaks in our aquariums. They are usually caused by a flaw or failure
in the sealant, either during construction of the tank, or - over time the
sealant can simply become weak and begin peeling away from the glass.
The good news is that repairing problem leaks such as this, are actually not as difficult a task as you may think.
Here's a scenario you may be familiar
with ....
You
just bought a new or used aquarium and are rushing home so you can
get it filled with water and start adding inhabitants ......
-
STOP - !!
A good rule of thumb - whether you have a new or
used aquarium is to inspect all areas for any imperfections, small
holes, chips in glass, peeling silicon etc. Any imperfections should be dealt with before adding water.
Look
under and around the plastic trim and mouldings.
Used tanks especially need a good visual exam. It may be necessary
to reseal complete tank if over 6-7+ yrs. of age.
Note:
Be sure to use only a non-toxic 100% silicon sealant appropriate for aquarium use. If your not sure ask.
The old saying that
"An Ounce of Prevention is Worth a Pound of Cure" applies here..!!
Clean
and dry aquarium thoroughly. If you
find an area that needs attention, cut
out the old silicon with a razor blade. If a
leak is apparent on a side seam, remove all the sealant from the entire length of
seam, clean
the area with rubbing alcohol.
Remember
....new
silicone does not stick to cured silicone.
Run
a continuous bead of new sealant in seams, smooth out bead with a
wet rag, popsicle stick, or your finger...( I like the finger
method )
Once
your finished - allow to
sealant to cure following manufacturer's directions (usually 24
hrs)... Adding water too soon will weaken the seal and all the
work you've done so far !!
Trim
off any excess silicone with razor blade...
After your repairs have had a chance to cure, I recommend
a good rinse and final (hopefully) re-fill to test for leaks once
again.
If
no leaks are apparent your now on your way
Quote
of the month ......
"Horse sense is the thing a horse has
which keeps it from betting on people."
W.C. Fields
------------------------------------------------------------------------------------ |
